Capability

Design verification, analysis & assurance

Structural, mechanical and hydraulic analysis, FMECA, factory acceptance testing and third-party certification.

We verify that equipment meets its functional, structural and safety requirements across all relevant operating and fault conditions.

Engineering analysis

Analysis is applied at component and system level: load-case development, global and local structural analysis, hydraulic and mechanical sizing and assessment of dynamic effects from vessel motion, cyclic loading and transient events. Verification is tied to the intended operating envelope, with limiting cases, degraded modes and abnormal conditions explicitly considered.

We run detailed structural and mechanical finite element analysis, fast meshless analysis for rapid design optimisation early in a project, structural analysis to the relevant codes and hydraulic circuit simulation to confirm operating modes and fault responses.

We apply FMECA (failure mode, effects and criticality analysis) and structured risk assessment to identify which failure modes matter most, and design the redundancy and the protective functions around them.

Documented hand calculation runs alongside the numerical work. When a classification society or marine warranty surveyor asks to see the basis of a result, it is traceable.

Testing & assurance

Where practicable, systems are assembled, integrated and functionally tested before delivery, including factory acceptance testing (FAT) with customer witness on critical scopes, to confirm operation, interfaces and control behaviour. We routinely support third-party review, independent checking and classification involvement, with documentation, calculations and technical justification prepared accordingly.

Standards & certification

Equipment can be supplied with third-party certification where a project requires it, including support to the requirements of DNV, Lloyd’s Register, Bureau Veritas and ABS. We work to international and industry standards including Eurocodes, LOLER and the relevant offshore, marine and structural codes.

Marine warranty & independent verification

We prepare designs, calculations, load tests and documentation for third-party and classification verification of design and manufacture, including marine warranty survey (MWS) review. Where this supports a vessel modification or equipment installation, see naval architecture & vessel engineering.